Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4
Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4

Mopar OEM Clutch Pivot Fork, 03-05 Neon SRT-4

    Model Number :
$279.99
/
  • Have more than 30,000-40,000 miles on your factory Clutch Pivot Fork?
  • Ever notice that the engagement point of your clutch is getting lower and lower?
  • Ever notice that its getting harder and harder to get your car into gears?

 

If you have answered yes to any of the questions above, then you should replace your factory clutch pivot fork with a new one. (Note: We also recommend replacing the clutch pivot ball, sold separately)

 

This piece is inside the transmission bell housing, and its what the slave cylinder pushes on one side to depress the clutch throw out bearing on the other side against the clutch. This is a brand new replacement part from Mopar.

 

One of the photos on this page in the thumbnails above is a closeup of a worn fork and a stock fork. The clutch pivot fork pushes against the throwout bearing and over time, these two points wear down, and it doesnt fully depress the clutch anymore. This causes issues with putting your car into gear, and with making the engagement point of the clutch too low. So, if your already having problems, or if your about to change out your clutch, we recommend replacing this while your doing the work!

 

Note: This fork comes with a brand new boot and clip installed.

Questions & Answers loading...

Recently viewed

You may also like